ELECRAFT KAF2 Betriebsanweisung PDF herunterladen (Seite 22)

- 19 -

[ ]

If some of the above VCO control voltage readings are < 1.0 V, or some

of them are > 7.5 V, you may be able to shift the entire set of readings so that

they are all within the 1.0 to 7.5 V range. Switch to the band (and frequency)

that had the highest or lowest voltage, then adjust L30 to bring that reading

into range. Then re-measure all of the voltages to make sure they're in range.

If you have some voltages that are < 1.0 V and others that are > 7.5 V,

you may have installed the wrong value at one or more of the VCO capacitors

(C71 - C74) or varactor diodes (D21 - D26). Another possibility is that T5 has

the wrong number of turns or that you installed the wrong type of slug-tuned

inductor at L30. ALTHOUGH MOST LIKELY YOU EITHER FORGOT

TO CHANGE THE EXTENDED VFO RANGE (D19) SECONDARY

MENU SETTING TO “YES” (AS DESCRIBED ON PAGE 60), OR YOU

DID A HARD FACTORY RESET WHICH UNDID THIS CHANGE! If

you change any of these components OR THE (D19) SECONDARY MENU

SETTING, you need to repeat the VCO alignment procedure.

KAT2

KBT2

KPA100

KAF2

KDSP2

KNB2

K160RX

K60XV

KSB2

Multiple

REW•RK-FREE K2 ASSEMBLY

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 34 35

Keine Kommentare

ELECRAFT KAF2 Betriebsanweisung Seite 22