ELECRAFT KBPF3 Spezifikationen PDF herunterladen (Seite 8)

Remove both bottom covers from the K3 by removing the screws shown in Figure 2.

SEE NOTE

NOTE:

THESE THREE SCREWS

ARE 1/4" (6.4 mm) LONG

AND HAVE INSIDE TOOTH

LOCK WASHERS UNDER

THE SCREW HEADS.

ALL THE OTHER SCREWS

ARE 3/16" (4.8 mm) LONG

AND HAVE NO LOCK

WASHERS.

REMOVE ALL THE

SCREWS INDICATED

AND LIFT THE

BOTTOM COVERS

OFF.

ESD SENSITIVE!

WEAR A GROUNDED

WRIST STRAP OR TOUCH

AN UNPAINTED METAL GROUND

BEFORE HANDLING THE RF BOARD.

Figure 2. Removing K3 Bottom Cover.

As you install components and reassemble your K3, be sure all the screws are in place

and secure, but do not over tighten them. Failure to tighten all screws may result in poor

shielding of sensitive components, resulting in possible noise or birdies in the receiver as well

as other difficult-to-trace problems.

1 2 3 4 5 6 7 8 9 10 11

Keine Kommentare

ELECRAFT KBPF3 Spezifikationen Seite 8