ELECRAFT KBPF3 Spezifikationen PDF herunterladen (Seite 11)

Turn the K3 right side up to replace the top cover. Hold the top cover above the K3 and plug the speaker

wire into P25 on the KIO3 board at the left rear of the K3 as shown in Figure 5.

TO SPEAKE

ORIENT

CONNECTOR

AS SHOWN

KIO3 BOARD

IN BACK LEF

CORNER OF

CHASSIS

Figure 5. Connecting Speaker Cable.

Position the top cover on the K3. Note that the tab on the back center goes under the rear lip of the K3 rear

panel. Secure the top cover with the nine 4-40 3/16” (4.8 mm) black flat head screws you removed earlier.

REPLACE ALL THE SCREWS!

The K3's chassis has excellent rigidity despite its light weight. The screws that hold the top

cover in place are an important part of the structural design. Be sure to replace all the

screws and verify they are tight whenever you replace the cover or other panels

Enable the KBPF3 using the CONFIG menu as described in the Owner’s Manual.

This completes the installation of the KBPF3 module in your K3 transceiver.

1 2 ... 6 7 8 9 10 11

Keine Kommentare

ELECRAFT KBPF3 Spezifikationen Seite 11