ELECRAFT KBPF3 Spezifikationen

ELECRAFT® K3 HIGH-PERFORMANCE 160 – 6 METER TRANSCEIVER KBPF3 GENERAL COVERAGE RECEIVE OPTION INSTALLATION INSTRUCTIONS Rev B1, October 28, 20

10There are three connectors on the bottom of the KBPF3 board that must be properly mated to P44A, P44C and P44E on the RF board. Even though the c

11Turn the K3 right side up to replace the top cover. Hold the top cover above the K3 and plug the speaker wire into P25 on the KIO3 board at the l

2Contents Introduction...

3Introduction This manual covers the installation of the KBPF3 General Coverage Receive option in your K3 transceiver. Only a few basic hand tools

4 Elecraft 1-Year Limited Warranty This warranty is effective as of the date of first consumer purchase. It covers both our kits and fully assemb

5Inexpensive static dissipating work mats are readily-available that will steadily and safely drain off any charges built up on parts or circuit bo

6Parts Included The following parts should be included in your kit. Check to ensure you have them all. If any parts are damaged or missing, contact

7Installation Procedure Disconnect power and all cables from your K3. Remove the nine screws to free the top cover as shown in Figure 1. After the

8Remove both bottom covers from the K3 by removing the screws shown in Figure 2. SEE NOTESEE NOTESEE NOTENOTE:THESE THREE SCREWSARE 1/4" (6.

9Install two standoffs on the RF board that covers the bottom of the K3 as shown in Figure 3. (Note that the stiffening bar across the top of the K