ELECRAFT K3EXREF Bedienungshandbuch PDF herunterladen (Seite 4)

The new KSYN3A boards are shipped in ESD-safe envelopes. Do not handle them

without first taking the ESD precautions listed on page 6. Keep the synthesizers you remove

in those envelopes.

Like the original synthesizer, one pin of the multi-pin connector at the bottom has been cut and the

corresponding opening in the socket on the K3 RF board has been plugged to assist in properly aligning the

connectors when installing the board.

Figure 2. Original and New Synthesizer Boards.

Synthesizer Calibration

The original KSYN3 synthesizers required calibration as described in your K3 Owner’s Manual. The new

KSYN3A synthesizers do not require calibration. If you have firmware 5.03 or later installed in your K3 it

will recognize the new KSYN3A synthesizer(s) and the

CONFIG VCO:MD menu entry used by the calibration

procedure will no longer appear in the K3’s menu.

Customer Service and Support

Technical Assistance

You can send e-mail to [email protected] and we will respond quickly – typically the same day

Monday through Friday. If you need replacement parts, send an e-mail to [email protected]

. Telephone

assistance is available from 9 A.M. to 5 P.M. Pacific time (weekdays only) at 831-763-4211. Please use e-mail

rather than calling when possible since this gives us a written record of the details of your problem and allows us

to handle a larger number of requests each day.

Repair / Alignment Service

If necessary, you may return your Elecraft product to us for repair or alignment. (Note: We offer unlimited email

and phone support, so please try that route first as we can usually help you find the problem quickly.)

1 2 3 4 5 6 7 8 9 ... 16 17

Keine Kommentare

ELECRAFT K3EXREF Bedienungshandbuch Seite 4