ELECRAFT K3EXREF Bedienungshandbuch PDF herunterladen (Seite 3)

Introduction

This manual will guide you through the replacement of the KSYN3 synthesizer(s) in your K3 transceiver with

the new KSYN3A synthesizer(s). No test equipment is required. Only a few hand tools are needed to assemble

your kit (see page Tools Required on page 7).

Should you have difficulty, you'll have our full support via phone and e-mail. In addition, we hope you'll join

our growing and enthusiastic community of owner/builders via the Elecraft reflector.

Basic K3s have one synthesizer. If you have the optional KRX3 Subreceiver installed in your K3 there will be

two synthesizers. If your K3 has both synthesizers, the both must be the same type. You cannot mix the new

KSYN3A synthesizer and the older KSYN3 in the same K3!

If you have the optional KRX3 Subreceiver installed in your K3 there will be two

synthesizers. If your K3 has both synthesizers, the both must be the same type. You cannot

mix the new KSYN3A synthesizer and the older KSYN3 in the same K3!

Checking Synthesizer Types

If you are unsure which synthesizer is installed in your K3, open the K3 top cover (see Removing Top Cover on

page 8). You don’t need to remove the top cover completely. Only lift it far enough to see the synthesizers (see

Figure 1). The old and new synthesizers are shown in Figure 2.

Figure 1. Synthesizer Locations in the K3.

1 2 3 4 5 6 7 8 ... 16 17

Keine Kommentare

ELECRAFT K3EXREF Bedienungshandbuch Seite 3