Elecraft KIO2 Bedienungsanleitung PDF herunterladen (Seite 10)

Table 4 SW command values for emulation of two-switch combinations.

Function Switch Combination <nn>

FINE RIT on/off XFIL RIT 33

Direct Freq. Entry BAND+ BAND- 34

Fwd/Refl Power DISPLAY TUNE 35

AGC on/off AGC PRE/ATTN 36

XFIL/AFIL status XFIL AGC 37

notch fil. on/off AFIL SPLIT 80

noise red. on/off AFIL REC 81

Table 5 SW command values for menu entry selection.

Primary Menu Secondary Menu

Entry <nn> Entry <nn> Entry <nn> Entry <nn>

ST L 38 LCD 46 SLCH 54 RTC 62

ST P 39 GRPH 47 RATES 55 RIT 63

T-R 40 OPT 48 DOT 56 ACC 64

INP 41 ATU 49 FPLY 57 AT2 65

RPT 42 RANT 50 PORT 58 PA 66

IAB 43 CAL 51 SPLT 59 TRN1 67

SSBA 44 PF1 52 Po28 60 TRN2 68

SSBC 45 PF2 53 RTTY 61 TRN3 69

UP (Move VFO or Menu Entry/Parameter Up; SET only)

See DN.

TQ (Transmit Query; GET only)

RSP format: TQ0 (receive mode) or TQ1 (transmit mode). This is the preferred way to check RX/TX status since

it requires far fewer bytes than an IF response.

TX (Transmit Mode; SET only)

SET format: TX; (no data). Used to initiate transmit (in SSB and RTTY modes only) by pulling PTT low. Use the

RX command to cancel TX. RX/TX status read is available in the IF response.

XT (XIT Control; GET/SET)

SET/RSP format: XTn; where n is 0 (XIT OFF) or 1 (XIT ON).

1 2 3 4 5 6 7 8 9 10

Keine Kommentare

Elecraft KIO2 Bedienungsanleitung Seite 10