ELECRAFT KBPF3 Spezifikationen PDF herunterladen (Seite 7)

Installation Procedure

As you install components and reassemble your K3, be sure all the screws are in place

and secure, but do not over tighten them. Failure to tighten all screws may result in poor

shielding of sensitive components, resulting in possible noise or birdies in the receiver as well

as other difficult-to-trace problems.

Removing the Top Cover

Disconnect power and all cables from your K3.

Remove the nine screws to free the top cover as shown in Figure 1. After the cover is open, lift it gently to

reach the speaker wire connector. Unplug the speaker then set the top cover aside in a safe place.

REMOVE

9 SCREWS

HOLDING TOP

COVER.

TO OPEN COVER,

PRESS HERE TO

TILT FRONT EDGE UP

DO NOT

REMOVE THE

FOUR SCREWS

AT THE CORNERS

OF THE SPEAKER

OPENING.

PLACE UNIT

ON ITS SIDE FEET,

THEN TIP FARTHER

SO THE TOP COVER

SWINGS OPEN.

Figure 1. Removing K3 Top Cover.

CAUTION:

Touch an unpainted metal ground or wear a grounded wrist strap

before touching components or circuit boards inside the K3. See Preventing ESD Damage

page 4 for more information.

1 2 3 4 5 6 7 8 9 10 11

Keine Kommentare

ELECRAFT KBPF3 Spezifikationen Seite 7