ELECRAFT K3-Remote Bedienungsanleitung PDF herunterladen (Seite 4)

In my case it was COM20, the speed of 38400 is default for Elecraft K3.

So, to start remote control, I go to

http://192.168.1.227:8090/ then “Status”, click on “Connect”

button, when hear air noise, run HRD.

4. How to control Transceiver with K3/0-Mini

Set the radio to mode 14 – Elecraft twin. In this case remote transceiver controlled directly by K3/0

panel. Both RRC's serial settings COM1 has to be set to Mode-7. The baud rate does not have to be the

same as COM2.

Use COM1 on the control RRC for N1MM or Ham Radio Deluxe. You may wish to change the control

RRC's COM1 "Use USB Com Port as COM1" to YES and then use that virtual serial port (see what

Windows assigned it in the Device Manager).

5. How to configure N1MM logger with K3/0-Mini

On the picture above Com2 corresponds to virtual port Com1 on RRC and used to control transceiver;

Com4 corresponds to Com0 on RCC and configured to key CW.

1 2 3 4 5

Keine Kommentare

ELECRAFT K3-Remote Bedienungsanleitung Seite 4