Elecraft • www.elecraft.com • 831-763-4211 ELECRAFT KXPD1 PLUG-IN KEYER PADDLE Assembly and Operating Instructions Revision B,
2 Parts List Drawing Description Qty Part No. Lever, spring steel i DO NOT FLATTEN OR BEND THE LEVER. IT IS FABRICATED WITH A PRECISE AMOUNT OF T
3 Assembly Break off the ground tab of the plug (longest of the 3 terminals) by flexing it a few times (Figure 1). Figure 1 Thread the plug into
4 Remove the insulation from 2" (5 cm) of the insulated wire. Cut it into two 1" (2.5 cm) lengths. Attach one wire to each PC board at t
5 Locate the two molded rubber grips. Note that the grips have a raised surface detail on one side only. This surface must be pointing outward when
6 Installation and Test Turn on the KX1 and plug in a pair of headphones or a speaker. If you're using headphones, put them on now. To safel
7 Test the paddles, pressing them at approximately the points indicated by the arrows in Figure 8. After you have confirmed that both paddles work
Kommentare zu diesen Handbüchern